ADSM Client
1997-02-07 13:34:57
To: OAS --LMS1
FROM: Betsy Moir (TTCEDM) Ext 85020
VM Tech Services
email: elizabeth.moir AT vm.ssw.abbott DOT com
Subject: ADSM Client
I'm assuming that those X's after TCPServerAddress actually have the server
IP address numbers in them. If not, they should. Additionally, you need to
add a line which reads:
NODENAME nodename
where nodename is the nodename you registered the client as when you set them
up on your server.
Hope this helps. If I were you I would check out the sample DSM.OPT
suggestions. There are some INCLUDE/EXCLUDE options you will probably want in
there as well as some client options.
Good Luck.
Betsy
*** Forwarding note from OWNERAD1--INTERNET 97/02/07 08:14 ***
TO: INTERNET ADSM-L AT VM.MARIST DOT EDU
FROM: OWNERAD1 INTERNET OWNER-ADSM-L AT VM.MARIST DOT EDU
DATE: 02/07/97 08:14
SUBJECT: ADSM Client
COPYLIST:
Hi all,
I have just configure the Server(ADSM) and is up and running but
when I tried to to run the client site.. it give me an error msg:
of the following,
Unknown client node name.
Policy domain not define.
Rejected Node ID.
My dsm.opt file(AIX) is as follow:
=================================================
Server name ADSM
TCPServeraddress XXX.XXX.XXX.XXX
TCPPort 1500
TCPBuffsize 8
TCPWindowsize 0
=================================================
My dsm.sys file is as follow:
=================================================
Servername ADSM
COMMmethod TCPip
TCPPort 1500 TCPServeraddress XXX.XXX.XXX.XXX
=================================================
Could anyone advise me.. on this. Thanks..
Best Regards,
Joseph Tan (E-mail address: tonyjoe AT singnet.com DOT sg)
|
|
|