Re: mtlib command -L
1996-04-03 20:09:18
I get the same thing! Are you doing this with -a or -C. I only tried -a as
I don't really want to change categories.
>The 'mtlib' command, supplied with the 3494 as an AIX command to
>operate on the 3494, has a -L option for specifying a list of tape
>volsers. However, the device drivers manual says naught about how
>to specify those volsers via -L, and attempting all manner of
>variations (even with just one volser) yields the error message:
> mtlib: Error reading Volume serial number list
>
>Has anyone figured out how to use the -L option? Or is there a
>defect in the mtlib command?
>(The alternative is to use the -V option to specify one volume at
>a time, which makes for carpal tunnel.)
> thanks, Richard Sims, Boston University OIT
>
>
----------------------------------------------------------
Chris Hopkins cjhopkin AT on.bell DOT ca
Chris Hopkins cjhopkin AT on.bell DOT ca
Sr. System Designer
Highway 407 Electronic Toll Collection System
Bell Sygma Telecom Solutions
Toronto: (416) 215-2910
Ottawa: (613) 781-4544
----------------------------------------------------------
=========================================================================
|
|
|