Delay what?  Delay the status polling?  No.  That's a separate issue from
the config check.  The config checks run along side the status polling and
the time they take should not interfere with status polling.  Delay the
config check, which happens only once per day by default?  Yes.  But how
long a time-out are we talking about? A few seconds per node?

As I see it, if you have devices which should never be SNMP polled you have
two choices.  You can raise the config check interval just for them to some
really high value (say once a month?) in xnmsnmpconf,  or you can indicate
in the seed file devices which should never be SNMP polled using a caret
(^) and an address range.  At least that's my understanding.

James Shanks
Level 3 Support  for Tivoli NetView for UNIX and Windows
Tivoli Software / IBM Software Group


                                                                           
             "Hill, Channing"                                              
             <CHill AT bbandt DOT com                                           
  
             >                                                          To 
             Sent by:                  nv-l AT lists.ca.ibm DOT com             
  
             nv-l-bounces@list                                          cc 
             s.ca.ibm.com                                                  
                                                                   Subject 
                                       [NV-L] Status/Config Polling of     
             08/02/2006 10:38          non-snmp nodes and netmon           
             AM                        performance                         
                                                                           
                                                                           
             Please respond to                                             
              Tivoli NetView                                               
                Discussions                                                
             <nv-l AT lists.ca DOT ib                                           
  
                  m.com>                                                   
                                                                           
                                                                           







Per previous posts and documentation,  Netview will use ICMP only to poll
NON-SNMP nodes for status. However, will it still try to perform a
configuration check (which is done via SNMP) per snmp.conf's time intervals
for "Configuration Polling Intervals".


I will probably be faced with adding several nodes to be monitored that
will not support SNMP (security reasons). My concern/question is,  would
these non-SNMP nodes cause netmon to slow down waiting on SNMP to time out
when it is restarted and it performs timed configuration checks. If I
understand correctly, netmon will still check nodes for SNMP when it is
restarted and during Configuration polling intervals.


Could someone please advise.


Thanks,
Channing Hill
EMS Analyst II
BB&T
(252) 246-3642 _______________________________________________
NV-L mailing list
NV-L AT lists.ca.ibm DOT com
Unsubscribe:NV-L-leave AT lists.ca.ibm DOT com
http://lists.ca.ibm.com/mailman/listinfo/nv-l (Browser access limited to
internal IBM'ers only)




_______________________________________________
NV-L mailing list
NV-L AT lists.ca.ibm DOT com
Unsubscribe:NV-L-leave AT lists.ca.ibm DOT com
http://lists.ca.ibm.com/mailman/listinfo/nv-l (Browser access limited to 
internal IBM'ers only)