RE: [NV-L] Demandpoll Problems
2006-07-19 09:08:20
Morning David,
Can you snmpwalk the device and/or confirm the device in
question is SNMP supported? You can do that by checking the object
properties.
HTH--Drew
Dear list,
NV714, FP3,
Solaris .
Last week I posted a question regarding demandpoll problem
(discovery). It was finally found that demoandpoll is not doing his
job for all devices, not only for the discovery.
When I issue demandpoll (from both GUI and command line), it only gives back the
status of the interfaces and verify node name. No more checking interface table,
arp cache, admin/oper status etc. as before. I did ovtopofix -A (brook after two
hours) before that happened. Later I did ovtopofix with all the options
individually (not the -A), it finished in half a
hour.
But demandpoll is still not
doing.
Could
someone help? Thank you in
advance.
Regards, David
This message (including any attachments) contains confidential information intended for a specific individual and purpose, and is protected by law. If you are not the intended recipient, you should delete this message.
Any disclosure, copying, or distribution of this message, or the taking of any action based on it, is strictly prohibited. [v.E.1]
_______________________________________________
NV-L mailing list
NV-L AT lists.ca.ibm DOT com
Unsubscribe:NV-L-leave AT lists.ca.ibm DOT com
http://lists.ca.ibm.com/mailman/listinfo/nv-l (Browser access limited to
internal IBM'ers only)
|
|
|