|
Re: [nv-l] Problem with Event forwarding to TEC on Tivoli Netview 7.1.4
2005-12-09 02:04:53
You might try editing the tecad_nv6k.conf file and commenting out the 2
lines on State Correlation Engine. Perhaps it is just me, but I have
found this adapter more stable without SCE and you probably don't need
it unless you are correlating NetView and ITM events.
If you do this, take a copy of the file as you will find the GUI utility
that you run will overwrite your edits. As James said, you will need to
use serversetup to stop and start tecad_nv6k after any edits to its
configuration file.
Cheers,
Jane
Senny M wrote:
Hi there,
I am using IBM Tivoli Netview 7.1.4 in Windows 2003 platform. Also, I
enabled forwarding the Events to my TEC server using the batch file
provided by Tivoli Netview (tecconfig.bat). I observed an issue with
event forwarding to TEC Server from Netview server i.e. it is stopping
the event forwarding process at times. This forces me to start and
run the batch file entirely to resume the event forwarding. The
frequency is at least twice a day.
Did anyone come across with this issue? If so, could you please share
how this was resolved?
Also is there any other way that I can sort this issue using a simple
batch file running an executable instead of running the whole process
of event forwarding using the batch file provided by Netview
(tecconfig.bat)?
**Senthil Kumar M**
senthil.mani AT ustri DOT com
*GNOC*
4N Bhavani
Technopark, Trivandrum
PSTN: ++91-471-2335777 Extn 8653
VOIP: ++1-949-716-8239 Extn 1118
--
Tivoli Certified Consultant & Instructor
Skills 1st Limited, 2 Cedar Chase, Taplow, Bucks, SL6 0EU, UK
Tel: +44 (0)1628 782565
Copyright (c) 2005 Jane Curry <jane.curry AT skills-1st.co DOT uk>. All rights
reserved.
|
|
|
