nv-l
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

[nv-l] error when using the get value from mib

2005-09-20 08:24:13
Subject: [nv-l] error when using the get value from mib
From: "praveen kumar" <praveenkumar.nair AT ustri DOT com>
To: <nv-l AT lists.us.ibm DOT com>
Date: Tue, 20 Sep 2005 17:54:55 +0530

Hi all,

 

I am running netview for windows 7.1.4 ,I am trying to monitor the vpn tunnel status I found out the mib from pix version 7 but I am having pix version 6.3 when I browse through this mib and try to get the value error message

 

 

  

 Is this because this mibs are not supported in 6.3 ,I was not able to get this mib CISCO-IPSEC-FLOW-MONITOR-MIB-V1SMI.my for pix 6.3 any thoughts to share ,it was a bit of effort to  load this mib James shanks  helped me to get this done .thanks for James .

 

True regards,

Praveen

[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  RE: [nv-l] objectID Cisco, Javier Morate Guerrero
Next by Date:  RE: [nv-l] objectID Cisco, REIBENSCHUH Alfred
Previous by Thread:  RE: [nv-l] objectID Cisco, REIBENSCHUH Alfred
Next by Thread:  RE: [nv-l] error when using the get value from mib, praveen kumar
Indexes:  [Date] [Thread] [Top] [All Lists]