nv-l
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

RE: [nv-l] question about modifying objects in netview 7.1.3

2004-09-21 11:45:01
Subject: RE: [nv-l] question about modifying objects in netview 7.1.3
From: "Allison, Jason \(JALLISON\)" <JALLISON AT arinc DOT com>
To: <nv-l AT lists.us.ibm DOT com>
Date: Tue, 21 Sep 2004 11:30:47 -0400
You can use the API, but if you have netmon polling that IP device on interval, it will notice the incorrect status and change it back.  Start at "man OVwSetStatusOnObject", this will give you a start.  If you have any specific questions, feel free to ask.  Some statuses are "Reserved" and it wont allow you to change it via the API (eg Acknowledged), but there are programmatic ways around that.
 
Good luck,
 
Jason Allison
Principal Engineer
ARINC Incorporated
 
 -----Original Message-----
From: owner-nv-l AT lists.us.ibm DOT com [mailto:owner-nv-l AT lists.us.ibm DOT com] On Behalf Of Freeman, Michael
Sent: Tuesday, September 21, 2004 11:25 AM
To: nv-l AT lists.tivoli DOT com
Subject: [nv-l] question about modifying objects in netview 7.1.3

We are trying to find a way to modify an object in NetView. If we know the node name, and want to change its status from say down, to up, because of an additional verification that proved it was up, how would we go about doing it? Are there any utilities or where should I look in the API?

 

Thanks,

Mike

 

*** Note new e-mail address

--

Michael J. Freeman

Netco Government Services

mfreeman AT netcogov DOT com

--

 

[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  [nv-l] question about modifying objects in netview 7.1.3, Freeman, Michael
Next by Date:  [nv-l] Netview and TEC Integration, John Altman
Previous by Thread:  [nv-l] question about modifying objects in netview 7.1.3, Freeman, Michael
Next by Thread:  RE: [nv-l] question about modifying objects in netview 7.1.3, Freeman, Michael
Indexes:  [Date] [Thread] [Top] [All Lists]