Hi
list,
nv 7.1.4+fp1, sa
1.2.1, linux rh es 2.1, HP Procurve 2524 with single vlan called
VLAN1.
I'm doing a little
testing with switch analyser & although the brain maybe clogged by hayfever
I can't find a document that describes the output from "ITSL2_reports -r layer2
-d". If anyone can point me to doc's on this that would be great.
Just in case below is the output I'm getting;
192.168.1.254/192.168.1.254
[2/2/0.0.0.0] ===>
[jaws-w2k/192.168.1.11 - /0/192.168.1.11]
[5/5/0.0.0.0]
===> [172.16.1.1/172.16.1.1 -
eth1/3/192.168.1.59]
[192.168.1.1/192.168.1.1 - /0/192.168.1.1]
* [tiree-w2k3/192.168.1.10 -
/0/192.168.1.10] [ws01/192.168.1.14 - /0/192.168.1.14]
*
* This interface has been
placed on the layer 2 segment by "default" and is not necessarily
connected to the specified port.
192.168.1.1 is a
router which is connect to an HP Procurve 2524 (192.168.1.254 mgmt ip) on port
24 of the switch
192.168.1.14 is a pc
attached to port 13 of the switch
172.16.1.1 &
192.168.1.59 are interfaces on a linux router
172.16.1.202 is the
netview server
The Linux router and
netview server are both vmware images running on the host
192.168.1.10
A few questions to
get me going....;
192.168.1.254/192.168.1.254 => what is this telling
me? My switch ipaddr is 192.168.1.254 - but why print it
twice?
[2/2/0.0.0.0] => Just plain confused. This
device is in port 2 of my switch, but why print that twice? What's the
0.0.0.0?
[5/5/0.0.0.0] => is there anything I can do to
remove the * from 192.168.1.1 and 192.168.1.14 which are both real machines
plugged into different ports on the switch & get them reporting the correct
port numbers?
Any help much
appreciated
K
|