RE: [nv-l] Un-numbered Interfaces.
2004-04-29 01:47:51
unnumbered interfaces usually show up
with ip address 0.0.0.0.
On Cisco devices the unnumbered link
is discovered from the CDP cache.
On both sides the router of the other
end has to be there.
I'm not sure but I think this is the
place NetView is looking for:
snmpwalk <YourCiscoRouter> .1.3.6.1.4.1.9.9.23.1.2.1.1.6
B.t.w. What NetView version? What OS?
Oliver
"Brian Backer"
<brian.backer AT centurytel DOT com>
Sent by: owner-nv-l AT lists.us.ibm DOT com
28.04.2004 16:07
|
To
| <nv-l AT lists.us.ibm DOT com>
|
cc
|
|
Subject
| RE: [nv-l] Un-numbered Interfaces. |
|
Oliver,
I have discovered both sides,
but there is still no representation inside the router sub-map to show
the interface.... should there / could there be?
b
-----Original Message-----
From: owner-nv-l AT lists.us.ibm DOT com [mailto:owner-nv-l AT lists.us.ibm DOT com]On
Behalf Of Oliver Bruchhaeuser
Sent: Tuesday, April 27, 2004 2:48 AM
To: nv-l AT lists.us.ibm DOT com
Subject: RE: [nv-l] Un-numbered Interfaces.
to discover the unnumbered interfaces you have to discover both sides (Routers)
of the unnumbered link.
Oliver
"Brian Backer"
<brian.backer AT centurytel DOT com>
Sent by: owner-nv-l AT lists.us.ibm DOT com
26.04.2004 23:30
|
To
| <nv-l AT lists.us.ibm DOT com>
|
cc
|
|
Subject
| RE: [nv-l] Un-numbered Interfaces. |
|
thanks for the reply..
I hadn't, but I just went into there and it's set to "yes" However,
when I rediscover a device, it doesn't show any interfaces that are un-numbered.
What should I be expecting to see with an un-numbered interface?
I know they're on the device.. .just doesn't show them..
b
-----Original Message-----
From: owner-nv-l AT lists.us.ibm DOT com [mailto:owner-nv-l AT lists.us.ibm DOT com]On
Behalf Of ray.smith AT clorox DOT com
Sent: Monday, April 26, 2004 4:03 PM
To: nv-l AT lists.us.ibm DOT com
Subject: Re: [nv-l] Un-numbered Interfaces.
there is an option in the serversetup gui for unnumbered ip address support.
its under the heading of set options for daemons, then set options for
topology , discovery, ... then
set options for netmon daemon
have you been there?
Ray Smith
| "Brian Backer"
<brian.backer AT centurytel DOT com>
Sent by: owner-nv-l AT lists.us.ibm DOT com
04/26/2004 12:49 PM
Please respond to nv-l
|
To: <nv-l AT lists.us.ibm DOT com>
cc:
Fax to:
Subject: [nv-l] Un-numbered
Interfaces. |
I have question that I need some help with. I have a request from
a customer to monitor some cisco "un-numbered" interfaces. I've
only ever monitored IP and IPX interfaces. Anyone here monitoring
un-numbered interfaces? if so, how?
thanks
b
|
|
|