Does the network end in .0? If so, did you try it without
the .0 at the end?

Paul


reamd AT Nationwide DOT com wrote:

Hi All,
         I putting together a map for a customer and when adding Network
Address or Location I received the following: The Network "Ip address" is
valid, but has not been discovered. Discover it before using scope...  The
problem is, that it has been discovered and on the IPMap. I deleted it from
the map and rediscovered it then attempted to add it again to the scope and
received the same message. Any Idea's?

Thanks, Dave

AIX 5.1
7.1.4