/usr/OV/conf/C/trapd.conf

This could be a problem because you will "lose" everything you added custom 
after install. NetView will lay down a new one and your old one will reflect 
traps that are not in the new one. Make sure you can identify the traps that 
were added and also have those mib2trap files available before hand so you can 
re-add them. I do not think it would be wise to just use your old trapd.conf 
since the new one will undoubtedly have new stuff for NetView as well.

-----Original Message-----
From: owner-nv-l AT lists.us.ibm DOT com [mailto:owner-nv-l AT lists.us.ibm DOT 
com]On
Behalf Of Brian W Green
Sent: Tuesday, February 10, 2004 10:31 AM
To: Netview Mailing List
Subject: [nv-l] Upgrading from 711 to 714


I am starting to plan to migrate my system from NV 711 to 714.  I have
tried this as an upgrade install - every time it dies on me at various
places.  I am now planning to do a complete deinstall and reinstall, but
before I do this, I need to plan out how to keep all the customizations
and reload them after the install completes.  Things I can think of:

Topology
MIBS
SNMP Collect
Web GUI Users
SmartSets
Configurations with serversetup

Other than going through everything and recording every config to be
re-done after install, does anyone know of a command or commands to do
this?

Thanks,

Brian

Brian W. Green
IBM Certified Deployment Professional
CGI Information Systems and Management Consulting
275 Slater Street, 14th Floor
Ottawa, Ontario
K1P 5H9
(613) 234-2155
brian.green AT cgi DOT com