Netview 7.1.3   Solaris 2.7  
I have a large frame relay hub and spoke network with ISDN use as backup
only.  Netview is one router hop away from all remote devices. I am only
monitoring Cisco Switches in my remote locations, and Netview is only setup
to receive UP/DOWN status of the remote switches.  
 When the frame goes down and the ISDN comes up, events are being generated
by Netview that a switch is down. Since I have ISDN connectivity to the
remote site, I can only assume that Netview is not getting a reply from the
poll sent. If I read my SNMP configuration correctly, Netview will poll
devices every 5 minutes, re-try 3 times, and timeout after 2 minutes. 
Okay here are my questions: Is this normal? Do I have something configured
incorrectly? Are Netview polls not reaching the switches because of
congestion and lower bandwidth of ISDN ? 
Any advice welcome.

Richard Kulikowski 
Waste Management
www.wm.com





---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)