Those are some of the environmental variables for trap data.

On page 189 of the Administrator's Guide for UNIX version 6.0:

"NVATTR_<1-50> Specifies the MIB attribute where 1-50 is the variable binding 
number".

So, if a trap sends two variables where the first is the hostname and the 
second is an interface, then NVATTR_1 = myhost and NVATTR_2 = eth0

-----Original Message-----
From: Kurt F. Rago [mailto:kurtr AT checkfreeinvsvcs DOT com]
Sent: Tuesday, July 09, 2002 11:32 AM
To: nv-l AT lists.tivoli DOT com
Subject: [nv-l] NVATTR




Hello all,

This is a pretty general question, I just started using Netview agian and
its been somtime I am weeding through a few perl scripts that were setup
and they have an environment variable pointing to the follwoing

NVATTR_2
NVATTR_3

could anyone explain what there are?

thx all....




---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)