I believe you are right, snmpCollect covers it. One thing, though. If
you change something in mib.coerce that affects anything that has
been collected on before, you need to purge that collected data.
Once the unit is stored in the ! file, it is not  changed until you delete
that file.

Cordially,

Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit



                                                                                
                                                  
                      netview AT toddh DOT net                                  
                                                         
                      (Todd H.)                To:       nv-l AT lists.tivoli 
DOT com                                                    
                                               cc:                              
                                                  
                      06/24/2002 08:17         Subject:  [nv-l] data 
collection/thresholds, config files, daemons                 
                      PM                                                        
                                                  
                      Please respond to                                         
                                                  
                      nv-l                                                      
                                                  
                                                                                
                                                  
                                                                                
                                                  




Greetings,

I'm creating procedures for adding trap support for some new devices
that will be followed by other NetView administrators.  I'd like to be
able to specify the procedures completely from the command line by
distributing a text file that can be appended to each of the
configuration files that are affected.

When changing various configuration files, which daemons must be
restarted for the change to be noted to the running daemons?
Unfortunately the man page for each of these really doesn't say.

mib.coerce   ->  snmpCollect is my best guess?
mibExpr.conf -> snmpCollect ?
snmpcol.conf -> snmpCollect ?

or do all deamons need to be brought down?

Is this documented anywhere?

TIA for any insight or advice!

Best Regards,
--
Todd H.
http://www.toddh.net/

---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)