that's what I tried before sending the question. But
it did not have any effect. Are you sure the timeout
we specify in snmpconf is not just for snmp requests
and does not apply to the ping command?
Thanks
 
--- James Shanks <jshanks AT us.ibm DOT com> a écrit : > This
is basic SNMP configuration.  As I recall you
> are on UNIX.  Use 
> xnmsnmpconf  from the command line.
> 
> James Shanks
> Level 3 Support  for Tivoli NetView for UNIX and NT
> Tivoli Software / IBM Software Group
>  
> 
> 
> 
> 
> 
> "can huynh" <can.huynh AT sympatico DOT ca>
> 03/19/2002 04:07 PM
> 
>  
>         To:     <nv-l AT lists.tivoli DOT com>
>         cc: 
>         Subject:        [nv-l] ping timeout in NV
> 
>  
> 
> Hello,
> I am wondering if there is a way to set the timout
> for the ping command 
> used by netmon to check the status of network
> equipments.
>  
> We have the following problem. 
> Our network is relatively slow these days and reply
> to ping can take 
> several seconds.
>  
> Netmon sometimes interpret that as an interface
> down. I just want to 
> increase ping timout to say 5 seconds to prevent
> that.
>  
> Is there a way?
>  
> 
> 
> 
>
---------------------------------------------------------------------
> To unsubscribe, e-mail:
> nv-l-unsubscribe AT lists.tivoli DOT com
> For additional commands, e-mail:
> nv-l-help AT lists.tivoli DOT com
> 
> *NOTE*
> This is not an Offical Tivoli Support forum. If you
> need immediate
> assistance from Tivoli please call the IBM Tivoli
> Software Group
> help line at 1-800-TIVOLI8(848-6548)
>  

___________________________________________________________
Do You Yahoo!? -- Une adresse @yahoo.fr gratuite et en français !
Yahoo! Mail : http://fr.mail.yahoo.com