On Cisco

no snmp enable traps snmp

(this turns off all SNMP traps including config changes, TCP sessions etc.)

On Windows 2K (and probably NT)

Check box on the SNMP configuration panel that sends auth traps

Those are the two platforms I know of

-----Original Message-----
From: Eric Pobst [mailto:epobst00 AT yahoo DOT com]
Sent: Thursday, March 07, 2002 8:46 AM
To: nv-l AT lists.tivoli DOT com
Subject: [nv-l] SNMP Authentication Errors


Greetings,

Does anyone know a method for disabling the passing of
SNMP Authentication Errors to NetView at the agent
level?  Basically, the network group here uses
OpenView to constantly poll the Network looking for
new devices on the network which creates quite a load
of Authentication errors on the servers NetView is
managing.  Unfortunately snmpset ability is not an
option to disable these (we only access agents with
Read only community).  I was hoping to disable at the
agent configuration level, if such an option exists.  
Thank you,
Eric Pobst

__________________________________________________
Do You Yahoo!?
Try FREE Yahoo! Mail - the world's greatest free email!
http://mail.yahoo.com/

---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)