RFI is controlled by the "-K" flag (-K1 turns it on, -K0 turns it off). it 
is on by default in 6.0.3 and 7.1 and all subsequent releases.  You 
control it by setting the option in serversetup.

James Shanks
Level 3 Support  for Tivoli NetView for UNIX and NT
Tivoli Software / IBM Software Group
 





reamd AT Nationwide DOT com
03/06/2002 07:08 AM

 
        To:     Vikas Kumar Gupta <VGupta AT bangalorelabs DOT com>
        cc:     "'nv-l AT lists.tivoli DOT com'" <nv-l AT lists.tivoli DOT com>
        Subject:        Re: [nv-l] Router Fault isolation

 


It's mentioned in release notes of 6.03 as being active by default, so I
would assume that it is active by default in 7.1 since there is no mention
of it in the 7.1 release notes...


  
                          Vikas Kumar Gupta   
                          <[email protected]  To: 
"'nv-l AT lists.tivoli DOT com'" <nv-l AT lists.tivoli DOT com>  
                          om>                      cc:     
                                                   bcc:     
                                                   Subject:    [nv-l] 
Router Fault isolation 
  
  
                          03/06/2002 05:20 AM    
  
  




Hello,
Does this feature works by default in Netview 7.1 or some script and
modification to netmon.lrf is required??
thanks and regards


vikas gupta
Bangalore Labs Ltd








---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)