Re: How to tell NetView not to discovered/display subnets associated with routers in seedfile
2001-11-15 09:47:23
Don,
Because those routers you are managing has an interface in those
subnets...NetView MUST discover and put those on the map. Those subnets
will only include router interfaces unless you "manage" them, then it will
do discovery within that subnet.
If you feel bogged down in your map by those, use the location.conf to put
those into a special "unmanaged subnet" location. This should clean up
your map quite a bit.
Kind regards,
Stephen Hochstetler shochste AT us.ibm DOT com
International Technical Support Organization - Austin
Office - 512-436-8564 FAX - 512-436-8701
|
|
|