Re: Load Cisco MIBs/traps
2001-11-13 16:39:50
This is a multipart message in MIME format. Do you have 6.0.1 or 6.0.2?
Over 100 new Cisco trap defs were added to the default trapd.conf in
/usr/OV/newconfig/OVSNMP-RUN/trapd.conf
If you haven't done so already, you can get these added to your existing
trapd.conf by running
nvaddtrapdconf /usr/OV/newconfig/OVSNMP-RUN/trapd.conf
and the merge will take place.
Then you can see what other trap defs you need and work on those.
You will have to add those manually or get the proper MIBs and run
mib2trap. But I would not try that until you have 6.0.2 installed as
there are fixes you will need there.
James Shanks
Level 3 Support for Tivoli NetView for UNIX and NT
Tivoli Software / IBM Software Group
CHANCELLOR.D.ELLIS AT customs.treas DOT gov
Sent by: owner-nv-l AT tkg DOT com
11/13/2001 04:08 PM
Please respond to IBM NetView Discussion
To: nv-l AT tkg DOT com
cc:
Subject: [NV-L] Load Cisco MIBs/traps
I am sorry if this has been covered on the list already.
What is the best way to load cisco MIBs? I have seen a script out there
that was last updated sometime in late 1997. Is there something similar
that is more recent? I need to format a large number traps for cisco and I
am looking for the quickest way. I am hoping there is something out there
that has all of the MIBs/trap definitions that will automate this step.
TIA
Do you have 6.0.1 or 6.0.2?
Over 100 new Cisco trap defs were added to the default trapd.conf in /usr/OV/newconfig/OVSNMP-RUN/trapd.conf
If you haven't done so already, you can get these added to your existing trapd.conf by running
nvaddtrapdconf /usr/OV/newconfig/OVSNMP-RUN/trapd.conf
and the merge will take place.
Then you can see what other trap defs you need and work on those.
You will have to add those manually or get the proper MIBs and run mib2trap. But I would not try that until you have 6.0.2 installed as there are fixes you will need there.
James Shanks
Level 3 Support for Tivoli NetView for UNIX and NT
Tivoli Software / IBM Software Group
| CHANCELLOR.D.ELLIS AT customs.treas DOT gov
Sent by: owner-nv-l AT tkg DOT com
11/13/2001 04:08 PM
Please respond to IBM NetView Discussion
|
To: nv-l AT tkg DOT com
cc:
Subject: [NV-L] Load Cisco MIBs/traps
|
I am sorry if this has been covered on the list already.
What is the best way to load cisco MIBs? I have seen a script out there that was last updated sometime in late 1997. Is there something similar that is more recent? I need to format a large number traps for cisco and I am looking for the quickest way. I am hoping there is something out there that has all of the MIBs/trap definitions that will automate this step.
TIA
|
|
|