I have 1 device that I want to monitor/manage, that for
security reasons I suppose, is set up to use port 260 instead of 161.
Is there any way that I can configure this within NetView?
Regards
Jeff
______________________________________________________________
Jeff Law
Email: jlaw AT ems-global DOT com
Technical Consultant
Mobile: +64 21 664 595
DDI: +64 7 854 7369
EMS-Global Ltd
Voice: +64 9 359 7003
P O Box 17 344
Fax: +64 9 300 6494
Auckland
NEW ZEALAND http://www.ems-global.com
______________________________________________________________