This is a multi-part message in MIME format.
Hi,
Can anyone help me in the automation of the ALERT via E-mail ? Like when i
see an alert interface down. Is if possible for me to configure an e-mail to
send out ? I am new to Netview. Can you guide please.
Thanks
Wakako Yamamoto
Network Admin
Fuji-Bank Tokyo
Tel: 81-3-5361-0924
Fax: 81-3-5361-6772
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
Hi forumers,
Configuration
-
Netview 5.1.3 + fixes,
-
Tru64 (Digital) UNIX 4.0f
-
Network implementation (FDDI, single and dual Ethernet - redundant transceivers)
based on DEC900 family (concentrators, repeaters, VnSwitches...)
When one of the redunded element is down, it has an impact on all of the
network elements (i.e. many interface down, then up traps generated by
netmon), including nodes that have no link with the failed element. After
analysis, failure of one element induce an unstability in the network,
with automatic reconfiguration which needs several seconds to recover (FDDI
and Ethernet redundancy, dynamic routing, ...). During this reconfiguration
phase, netmon fails pinging some interfaces, which seems reasonnable.
In order to coope with this unstability period, I've tried to configured
timeout and retries values for this polling (wildcard values in xsnmpconf),
but these values are automatically decreased by netmon down to 1 second
and no retries, which does not coope with the tolerance that was expected!!!
Is there any way to prevent netmon from adjusting dynamically these
values? If using SNMP polling, will netmon also adjust its internal timeouts?
Thanks for any help
Luc BARNOUIN
|