Re: SNMPv1/SNMPv2
2000-11-16 08:25:56
You cannot. It uses SNMP V1 as the version number because it does not
support the complex security mechanism implemented by SNMPV2c (and largely
ignored by most vendors). It sends a V1 style request even for V2 MIB
constructs, which should work fine for all agents and all constructs. I
am not aware of any cases where this does not work. Remember that V2 is
largely a superset of V1, and that if we automatically changed the V1/V2
browser to send only V2 requests, then some V1 agents could not respond.
James Shanks
Team Leader, Level 3 Support
Tivoli NetView for UNIX and NT
michael.hamm AT tudor DOT lu on 11/16/2000 04:02:05 AM
Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>
To: nv-l AT tkg DOT com
cc: (bcc: James Shanks/Tivoli Systems)
Subject: [NV-L] SNMPv1/SNMPv2
The NetView MIB-Browser always write the message:
"Sending SNMPv1 request to ......."
How can I enable it to send SNMPv2 requests?????
any idea
_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- SNMPv1/SNMPv2, michael . hamm
- Re: SNMPv1/SNMPv2,
James_Shanks <=
- Re: SNMPv1/SNMPv2, michael . hamm
- Re: SNMPv1/SNMPv2, James_Shanks
- Re: SNMPv1/SNMPv2, Bob Natale
- Re: SNMPv1/SNMPv2, mans . langert
- Re: Re: SNMPv1/SNMPv2, James_Shanks
- Re: SNMPv1/SNMPv2, Bob Natale
- Re: SNMPv1/SNMPv2, mans . langert
- Re: Re: SNMPv1/SNMPv2, Gareth_Holl
- Re: Re: SNMPv1/SNMPv2, Leslie Clark
- Re: SNMPv1/SNMPv2, mans . langert
|
|
|