I don't think you have to reinstall it. On the Netview menu there should be
an option to change the integration options. Just  change the page where
it specifies the address of the RME server.

Cordially,

Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit


"Barnes, Roy R" <RBarnes AT mail.sbic.co DOT za>@tkg.com on 11/07/2000 01:02:05 
AM

Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>

Sent by:  owner-nv-l AT tkg DOT com


To:   "'IBM NetView Discussion'" <nv-l AT tkg DOT com>
cc:
Subject:  [NV-L] Netview and Cisco RME integration





Good day all
Can anyone please tell me if there are any adverse effects of reinstalling
the Netview6 adapters through Cisco's integration utility. I need to change
the IP address of the RME server. ( Is there perhaps a quicker way of
changing the IP address).

Any help would be appreciated.

Roy Barnes
Standard Bank
Network Management Services


______________________________________________

Disclaimer and  confidentiality note

Everything in this e-mail and  any attachments relating to the official
business of Standard Bank Investment  Corporation (Stanbic) is proprietary
to the company. It is confidential, legally  privileged and protected by
law. Stanbic does not own and endorse any other  content. Views and
opinions are those of the sender unless clearly stated as  being that of
Stanbic.

The person addressed in the  e-mail is the sole authorised recipient.
Please notify the sender immediately if  it has unintentionally reached you
and do not read, disclose or use the content  in any way.

Stanbic can not assure that the integrity of this communication has been
maintained nor that it is free of errors, virus, interception or
interference.


             _______________________________________________