RE: RE: Error loading MIB file

I have a Cisco Catalyst 6509 and have accidentally used the SNMPV1
loader and got the same "Line 25: Error defining object: found
'MODULE-IDENTITY'" error. 

Later,
Mark LaFever

-----Original Message-----
From: KGKARASE AT hewitt DOT com [mailto:KGKARASE AT hewitt DOT com]
Sent: Friday, October 13, 2000 11:09 AM
To: nv-l AT tkg DOT com
Subject: FW: RE: [NV-L] Error loading MIB file




Mark,

How were you able to identify the MIB below in question being a SNMPv2
MIB? I
have received similar message below from trying to load vendor MIB's in
the
past.




From: Mark_LaFever AT cargill DOT com on 10/12/2000 01:55 PM

Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>

To:   nv-l AT tkg DOT com
cc:
Client:
Subject:  RE: [NV-L] Error loading MIB file



Chris,
      If you are using the snmpV1 loader to load snmpV2 mibs you will
get this message. Try using the snmpV2 loader in NetView and it should
work. Tools, MIB, SNMPV2, Load and then select the mib file.

Good luck,
Mark LaFever
Network Analyst
Excel Corp.
316-291-2926

-----Original Message-----
From: chrisp AT ucia DOT gov [mailto:chrisp AT ucia DOT gov]
Sent: Thursday, October 12, 2000 10:14 AM
To: NV-L AT UCSBVM.ucsb DOT edu
Subject: FW: [NV-L] Error loading MIB file



I am trying to load a mib file (ENTITY-MIB) for the Cisco Catalyst 6509
and am getting the following error.  I don't have a lot of experience
doing this and was wondering if someone could provide some help.
Thanks.


Error detected while loading MIB file ENTITY-MIB.MY
This MIB cannot be loaded until the following problem is corrected

Line 25: Error defining object: found 'MODULE-IDENTITY'

OBJECT IDENTIFIER
OBJECT-TYPE
TRAP-TYPE
::=


________________________________________________________________________
_
NV-L List information and Archives: http://www.tkg.com/nv-l
BDY.RTF
Description: RTF file