Re: Modifying then [re]-activating TEC forwarding ruleset


You either have to ovstop and then ovstart nvserverd or use the nvtecia -reload
command.  But as there was a problem with nvtecia that was not fixed until
5.1.3, you should probably use ovstop/ovstart to be sure, until you get 5.1.3
installed.  Otherwise you can experiment with nvtecia and see if it works for
you.  See the man page on nvtecia.

James Shanks
Team Leader, Level 3 Support
 Tivoli NetView for UNIX and NT



chuck_m_scanland AT reliantenergy DOT com on 08/02/2000 09:53:54 AM

Please respond to IBM NetView Discussion <nv-l AT tkg DOT com>

To:   IBM NetView Discussion <nv-l AT tkg DOT com>
cc:    (bcc: James Shanks/Tivoli Systems)
Subject:  [NV-L] Modifying then [re]-activating TEC forwarding ruleset





Hello,

I am a bit confused on how to activate the ruleset used for forwarding
events to TEC after I've made changes to it.  This is in NetView 5.1.2.  In
the admin guide it says that "If you edit a ruleset while it is active,
close and reopen the dynamic workspace window to put the changes into
effect."  Huh? Which dynamic workspace?

TIA,
Chuck Scanland
Tivoli/NetView Admin
Reliant Energy

_________________________________________________________________________
NV-L List information and Archives: http://www.tkg.com/nv-l