Re: Using an Expression in MIB Application
2000-04-06 08:15:15
Wouter,
See attached ARF. I'm using this to display the expression If%util (interface
utilisation) in a graph.
Just define the name of the mib expression in the xnmgraph statement.
Bernard
____________________________________________________________________
Bernard Disselborg Triple P Nederland B.V.
Consultant Enterprise Management
e-mail: bdisselb AT triple-p DOT nl PO Box 245
tel: +31 (0)347 353317 4130 EE Vianen
mobile: +31 (0)655 833355 The Netherlands
____________________________________________________________________
>>> W.M.de.Bruin AT DNB DOT NL 04/06/00 12:28PM >>>
Bernard,
I don t think I understand your answer...
What I want to do is to use an existing Mib Expression (Defined in
MibExpr.conf), to create a graph of say percentage Utilization of a router link.
However, I want to use this Expression in a MIB Application, rather than in a
Data Collection.
This provides me with the possibilty to select a node, and see an actual
representation of percentage bandwith utilization, as calculated by the
expression, updated every 5 seconds or so.....
Any suggestions?
Wouter de Bruin
Network Management Consultant
`Externe E-Mail wordt door DNB niet gebruikt voor het aangaan van
verplichtingen`
`Any e-mail messages from The Nederlandsche Bank are given in good faith
but shall not be binding
nor shall they be construed as constituting any obligation on the part of
the Bank.`
_________________________________________________________________________
NV-L List information (unsubscribing, policies, posting, digest version,
searchable archives): http://www.tkg.com/nv-l
/*
Created by: Triple P - Bernard Disselborg
Date: 22-10-99 16:56:31
*/
Application "ifutil" : "mibgraph"
{
Version "1.0";
Description {
"SNMP MIB Monitoring Application",
"Created by:",
" Triple P - Bernard Disselborg",
" Date: 991022",
}
Copyright {
"All rights reserved",
}
MenuBar "Performance"
{
"Network Activity" f.menu "Performance->Network Activity";
}
Menu "Performance->Network Activity"
{
"Interface Utilisation" f.action "ifutil";
}
Action "ifutil"
{
SelectionRule (isSNMPSupported)||(isSNMPProxied);
MinSelected 1;
Command "xnmgraph \
-title \"Ethernet Interface Utilisation: ${OVwSelections}\" \
-units \"Percent\" \
-poll \"10s\" \
-mib \"If%util::::::::\" \
${OVwSelections}";
}
}
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Using an Expression in MIB Application, W . M . de . Bruin
- Re: Using an Expression in MIB Application, Bernard Disselborg
- Re: Using an Expression in MIB Application, W . M . de . Bruin
- Re: Using an Expression in MIB Application,
Bernard Disselborg <=
- Re: Using an Expression in MIB Application, lclark
- Re: Using an Expression in MIB Application, Bernard Disselborg
- Re: Using an Expression in MIB Application, W . M . de . Bruin
- RE: Using an Expression in MIB Application, Rauwers, Laurens
- RE: Using an Expression in MIB Application, W . M . de . Bruin
- RE: Using an Expression in MIB Application, Rauwers, Laurens
|
|
|