Was this symbol on the map BEFORE you did all this?  My notes indicate that the
symbol is assigned at the time it is added to the map and not updated.  You
would have to delete and rediscover these devices (you could make a
collection/smartset of them first to make that easier) to get them to have
different symbols.

James Shanks
Tivoli (NetView for UNIX) L3 Support



Mythili Kannan <mythili_kannan AT YAHOO DOT COM> on 11/23/99 03:19:49 PM

Please respond to Discussion of IBM NetView and POLYCENTER Manager on NetView
      <NV-L AT UCSBVM.UCSB DOT EDU>

To:   NV-L AT UCSBVM.UCSB DOT EDU
cc:    (bcc: James Shanks/Tivoli Systems)
Subject:  Re: Symbol Question




Did you load the bitmap files corresponding to the
Cisco routers as well?  Did you run:
ovw -verify
ovw -config
ovw -fields
after you pulled all the symbols/fields/bitmap files?

- Regards, Mythili Kannan



--- "Frank W. Hansen"
<fhansen AT ENTERPRISEINNOVATIONS DOT COM> wrote:
> Greetings.  I have pulled all the CiscoView symbols,
> field definitions and
> oid_to_type / oid_to_sym defintions from  a
> CiscoView installation onto my
> NetView for NT server.  Everything loads up fine
> except my Cisco devices are
> only repesented by the generic cisco router icon.
> Any I've checked
> everything, oid_to_type, oid_to_sym, symbol
> registration files, field
> registration files, and class files.  Any ideas?
>
> Best Regards,
>
> Frank W. Hansen
> Tivoli Certified Enterprise Consultant
> www.EnterpriseInnovations.com
>
>
>

__________________________________________________
Do You Yahoo!?
Bid and sell for free at http://auctions.yahoo.com