Hello again,

is there anybody out there to answer just the following question:

I got the bitmap files for cisco devices and bay devices and would like
to see them in Netview, now I've put them int /usr/OV/bitmaps/C modified
the /usr/OV/conf/oid_to_sym and if I run ovw -config a window with a
router symbol appears for just a second and vanishes again - and then a
message "died on signal 10" appears on the screen from where I started
this.

What's the problem in this and what has to be done to get the proper
symbols for the cisco routers and bay hubs?

TIA
Peter

--
---------------------------------------------------------------------------

 mailto:Peter.Hadamovsky AT debis DOT com
 GSS GmbH
 Office: Fasanenweg 9 70771 Leinfelden-Echterdingen
 Phone/Fax: +49 711 972  -3525   /  -1930
 Mobile: +49 171 6943 156
----------------------------------------------------------------------------