Re: [Veritas-bu] HP ESL G3 Tape Library Barcode Issues
2013-11-05 10:21:02
Simon
If you go to the java admin gui to the
Media and Device management
è
Media
Robots
TLD(0) or whatever your robot is
Then netbackup should show you the volumes that it has picked up in the inventory.
One column should be the full 8 char barcode if the tape library passed on all 8 characters.
Another column should be the 6 char Media ID that netbackup uses.
If both are 6 characters then the issue is with the tape library, else it should be the netbackup rule.
If you have no volumes in netbackup’s inventory, try a preview it should show you both the barcode that it gets from the tape library and what it will do with
the barcode.
len
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu [mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu]
On Behalf Of Stier, Matthew
Sent: Tuesday, November 05, 2013 10:11 AM
To: Simon Weaver
Cc: VERITAS-BU AT mailman.eng.auburn DOT edu
Subject: Re: [Veritas-bu] HP ESL G3 Tape Library Barcode Issues
Documented here:
http://www.symantec.com/business/support/index?page=content&id=TECH10824
Hi All
Can someone advise on this?
I have implemented an HP G3 ESL Library under NBU 7.5 - However, I have a problem.
When doing the Inventory, it is showing the Media ID as the first 6 characters of the Barcode, rather than the last 6 characters of the Barcode.
For example, what I expect to see is W955L5, but what I am seeing is SSW995 being imported!
Any ideas as HP is telling me it is a NBU issue, but I was under the impression that by design, NetBackup imports the last 6 characters of the barcode.
|
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|