Re: [Veritas-bu] Converting standard client to a media server
2013-08-20 14:53:42
Robot arm?
Make sure you are NOT putting robotic "control" on the media server. You do
zone in the tape drives themselves. The robotic control is done from the
master.
-----Original Message-----
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of Dennis
Peacock
Sent: Tuesday, August 20, 2013 2:32 PM
To: VERITAS-BU AT MAILMAN.ENG.AUBURN DOT EDU
Subject: [Veritas-bu] Converting standard client to a media server
Just so we are clear here......
Node_A - Master/Media server
Node_B - Client
Conversion happens.....
Node_A - Master/Media server
Node_B - Client/Media server
Node_B is zoned so it can see the robot arm and tape drives that are attached
to Node_A.
+----------------------------------------------------------------------
|This was sent by dpeaco AT acxiom DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
Athena(r), Created for the Cause(tm)
Making a Difference in the Fight Against Breast Cancer
---------------------------------
CONFIDENTIALITY NOTICE: This e-mail may contain privileged or confidential
information and is for the sole use of the intended recipient(s). If you are
not the intended recipient, any disclosure, copying, distribution, or use of
the contents of this information is prohibited and may be unlawful. If you have
received this electronic transmission in error, please reply immediately to the
sender that you have received the message in error, and delete it. Thank you.
----------------------------------
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|