http://www.symantec.com/business/support/index?page=content&id=TECH135182
this may give some insite
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu [mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu]
On Behalf Of judy_hinchcliffe AT administaff DOT com
Sent: Friday, November 12, 2010 12:19 PM
To: bwindle AT wlgore DOT com; veritas-bu AT mailman.eng.auburn DOT edu
Subject: Re: [Veritas-bu] image cleanup process - run time
Been looking at this myself.
The image clean up is part of it.
By default it is set to 12 hours and can go a low as 8 hours.
A clean up will run after a restore if nothing else is running, or after a session of backups.
But it is the bpexpidate –deassigempty that expires images.
And this you cannot change when it runs
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu [mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu]
On Behalf Of Bobby R Windle
Sent: Friday, November 12, 2010 11:40 AM
To: veritas-bu AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] image cleanup process - run time
I understand Netbackup does a cleanup process on a regular bases when a job fails or ends etc. Also
I understand a nightly cleanup process runs to expire images on disk etc.. What time does this nightly cleanup
job kick off or better yet, how do I change this job to run at a specific time?
Thanks for the help.
Bobby Windle | W.L. Gore & associates, Inc.
Backup / Disaster Recovery Admin
work: 302 292 4026
cell : 302 588 7374
bwindle AT wlgore DOT com | http://www.gore.com