On Tue, Nov 9, 2010 at 3:48 PM, Nate Sanders <sandersn AT dmotorworks DOT com>
wrote:
> How do you exclude certain paths from an NDMP job? Unlike a regular host
> you can't put an include/exclude file on the client..
You need to check a couple of places.
First, in the NetBackup NDMP guide, you'll find references to commands
that you can pass to an NDMP client. In particular, SET is used to
set NDMP variables.
Next, in your NDMP client's guide, you'll find references that what
these are and how they're used. For NetApp filers, the documentation
is in the "Tape Backup and Recovery Guide" in the section "Environment
variables supported by Data ONTAP".
Cheers,
.../Ed
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|