Hi
You will need to know what was your offline catalog backup tape label
before you start:
1.
Make sure to call the server the same name as per the original
server.
2.
Get your robot and drives working on the new server.
3.
Install netbackup and patch to 6.5.3.
4.
Configure your robot and drives on netbackup.
5.
Don’t worry about any other configs at this stage. After
recovery the original settings will be back.
6.
Run media inventory and check under media tab, check in which
slot the catalog tape reside. Let’s say it’s in slot 5 for this example.
7.
On command line in …\VERITAS\volmgr\bin\ run robtest.
8.
Select your robot and then run m s5 d1 (this
means move slot 5 to drive 1)
9.
When it comes back successful loaded, exit out of robtest with Q.
10.
Then in …\VERITAS\NetBackup\bin\admincmd\ run bprecover –l –tpath
\\.\Tape0
11.
This should come back with catalog information. If not do #9
again but change to Tape1, Tape1 and so on until you get the catalog info.
12.
When you have the info, run in …\VERITAS\NetBackup\bin\admincmd\
bprecover –r –tpath \\.\Tape0 (or whatever tape
drive gave you your catalog info)
13.
It will start running and prompt you before it starts recovery
of the next part of the catalog.
14.
When done, stop and restart the netbackup services.
15.
Or in …\VERITAS\NetBackup\bin\admincmd\ run bprecover –r ALL – tpath
\\.\Tape0 (or whatever tape drive gave you your
catalog info)
16.
It will start running and when done, stop netbackup services and
restart.
17.
Check your settings and change where necessary.
Hopes this help.
JR
From:
veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of Martin,
Jonathan
Sent: Wednesday, October 21, 2009 7:17 PM
To: Spearman, David; VERITAS-BU AT mailman.eng.auburn DOT edu
Subject: Re: [Veritas-bu] NBU 6.5.3 master tanked
Install Netbackup and get your library working.
Put your catalog backup tape in the library.
Inventory the catalog backup tape.
Run Phase I and Phase II import of the Catalog Tape
Restore the drfile from the tape (unless you already have it
available)
Use the Catalog Recovery Wizard to restore the Catalog (and
other bits)
-Jonathan
From:
veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of Spearman,
David
Sent: Wednesday, October 21, 2009 1:07 PM
To: VERITAS-BU AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] NBU 6.5.3 master tanked
Our Windows 6.5.3 master tanked at the worst possible time. We
have a scaler i2000 with 10 lto-4 drives attached. I have read the instructions
from veritas on using bprecover a dozen times and cannot for the life of me
figure out what they are trying to say.
1.
Put tape in drive (fine, which one?)
2.
Run command bprecover –r –ALL –tpath device_path<tape
drive> ?????
The examples are garbage
Any help?
David Spearman
County of henrico