Have a look at NetBackup Admin Guide I under the topic 'Media Type
Mappings tab' and below that section called 'Default and allowable media
types'. You will have to change the default (GUI or vm.conf). This
however will only work for new media. You will have to change existing,
unassigned media manually with vmchange.

Regards

M.

-----Original Message-----
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of X_S
Sent: 02 July 2009 16:51
To: VERITAS-BU AT MAILMAN.ENG.AUBURN DOT EDU
Subject: [Veritas-bu] mounting lto3 tapes to lto4


M, thanks for your reply.

I have tried that, changing the nb density type of LTO3 to LTO4 but when
i run an inventory afterwards, i receive an Error 95 which seems to be
because of ACSLS:

"Inventory failed: media ID is not the specified media type(95)"

"Update failed: media ID LT0001 in database has media type 'HCART',
which differs from media ID LT0001 in the robot which is (according to
the media type returned from the robot, adjusted by media type mappings)
projected to have a media type of 'HCART3'"


+----------------------------------------------------------------------
|This was sent by xspak1 AT yahoo DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------


_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu