[Veritas-bu] Temporarily exclude tapes from being ejected by vault
2009-06-18 16:57:49
The vault selection screen allows you to select the date or time range to vault
- if set to only vault yesterday backups, it will not vault backups from prior
days.
Date: Thu, 18 Jun 2009 15:08:54 -0400
From: JBrownell <netbackup-forum AT backupcentral DOT com>
Subject: [Veritas-bu] Temporarily exclude tapes from being ejected by
vault
To: VERITAS-BU AT MAILMAN.ENG.AUBURN DOT EDU
Message-ID: <1245352134.m2f.309686 AT www.backupcentral DOT com>
We have been getting some negative feedback from our Operations staff about
having to reload tapes into our Tape Silo after our vault runs. The tapes are
always tapes that we have recalled from our outside Vault Company and are being
used for a system restore. Sometimes those restores can take significant time
and we would like to keep the tapes around in case the user needs any
additional files restored. Typically what happens is our next Veritas Vault
run will select those tapes and eject them causing the tapes to go offsite
again. Any suggestions for temporally marking those tapes so that they are not
selected by Veritas Vault?
Thanks,
Jim
:)
+----------------------------------------------------------------------
|This was sent by jim_brownell AT conseco DOT com via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
|
|