With regards to the source, I was meaning the source in the
duplication tab – it’s the only place in a vault profile where I’ve
see the word “source”. ;)
But it sounds like you say we should be able to use a stu group in
the “choose backups” tab. We’re running 6.5.3, and I’m
not seeing any way to select a stu group. We’ve got several basic
disk stu groups, along with a few tape stu groups, and I can’t see how to
select any of them in the choose backups tab. It would be nice to be able
to do this…
-devon
From: Scott Jacobson
[mailto:SJACOBSO AT novell DOT com]
Sent: Wednesday, April 01, 2009 6:41 PM
To: Peters, Devon C; veritas-bu AT mailman.eng.auburn DOT edu
Subject: Re: [Veritas-bu] Vaulting from disk storage groups
In 6.5.1+, you can
use and define a storage unit group as the source - then within the
Duplication Tab, selecting Advanced configuration, you'll need to define each
storage unit source with unique read/write drive configuration
and volume pool information. If the destination media sever(s) are local
(LAN), no problem. If not local, this is when SSO and remote
media/disk storage unit configuration options can possibly
help with your issue.
Scott
>>> "Peters, Devon C" <Peters.Devon AT con-way DOT com>
4/1/2009 5:55 PM >>>
You can't use storage unit
groups as the source, and I don't think Vault will let you use a storage unit
group as a duplication destination - you wouldn't want that anyway since the
duplications would probably end up going over the network.
You'll want to setup the
vault profile to choose all the backup images you want to duplicate (however
you decide to choose them). Then in the duplication tab use the
"advanced configuration" and add an entry for each media server -
just be sure that the destination for each server is a storage unit on that
same media server.
------------------------------
Date: Sat, 28 Mar 2009
20:06:51 -0400
From: jketter
<netbackup-forum AT backupcentral DOT com>
Subject: [Veritas-bu]
Vaulting from disk storage groups
To:
VERITAS-BU AT MAILMAN.ENG.AUBURN DOT EDU
Message-ID:
<1238285211.m2f.302465 AT www.backupcentral DOT com>
Can someone please explain
the best way to vault from disk storage units?
I have got a 5 media servers
enabled with the advanced disk option, all with local disk, contained within a
storage unit group.
I have also got the media
servers connect to multiple tape drives with SSO.
The backup images will be
spread over all storage units.
My question is about
vaulting from the disk storage unit to tape.
When configuring the vault
profile to vault to tape, should I point the source at the disk storage unit
(as you cant point directly to Storage unit group), and the destination to the
tape storage group?
Or, point the vault to all
storage units, and destination to individual tape drives connected to the media
servers?
+----------------------------------------------------------------------
+----------------------------------------------------------------------