Add the server to the tape drives and create storge units.


In netbackup add the drives for that server ( or if SSO add that server
to the drives).


-----Original Message-----
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of smehta
Sent: Monday, January 19, 2009 1:35 PM
To: VERITAS-BU AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] Media server is showind Active for Disk


Hi,

I have two media servers (one media server is also my master server).
The second media server (Solaris 10, NBU 6.5) is seeing all the tape
drives when I run sgscan or the device config. wizard in the NBU
console. However, when I go to devices -> media servers-> <media server
name> it shows up as Active for disk.

When I run the vmoprcmd command on the master the server shows up as
ACTIVE-DISK.

How can I change it to make the server Active for disk AND tapes.

Thanks in advance for your help

+----------------------------------------------------------------------
|This was sent by s.mehta AT ieee DOT org via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------


_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu

_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu