Good Morning Steve,

 

After adding the new tape drives did you run the procedure to reinstall the netbackup sg driver as written up in the  MediaMgr_DeviceConfig_Guide.txt file in the /usr/openv/volmgr directory?

 

If you following this procedure the devices should show up in the sgscan output

 

 

Cfgadm shows the 4 LTO3 drives. The dev/rmt entries are 0cbn thru 3cbn. But when I run scan or tpautoconf I get nothing nada zilch……..

 

 

 

What does cfgadm show ?

 

What /dev/rmt paths is it coming back with ????

 

Are you seeing any drives at all or nothing ???

 

 

Having a heck of a time getting my new Solaris 9 Media server to see tape. The setup is an L700 with 4 LTO 3 drives with a Decru Appliance in the path. Just spent 2 hours on the phone with Symantec support and got nowhere. Any one have any suggestions or tips …..?????  

The information contained in this email message and its attachments is intended only for the private and confidential use of the recipient(s) named above, unless the sender expressly agrees otherwise. Transmission of email over the Internet is not a secure communications medium. If you are requesting or have requested the transmittal of personal data, as defined in applicable privacy laws by means of email or in an attachment to email you must select a more secure alternate means of transmittal that supports your obligations to protect such personal data. If the reader of this message is not the intended recipient and/or you have received this email in error, you must take no action based on the information in this email and you are hereby notified that any dissemination, misuse, copying, or disclosure of this communication is strictly prohibited. If you have received this communication in error, please notify us immediately by email and delete the original message.