> I'm looking but haven't found it yet so I thought I would ask while I
> look.  I need a command to get the volume pool and bar code of a tape
> that volume pool was written to.

I usally use the output of 'vmquery -a' or 'vmquery -rn <#>' and parse
it.  I wish you could give both robot and pool to vmquery, but it only
wants to take one restriction.

> Bottom line is I need a way to identify the copied tape so I can eject
> it to be sent offsite.

Is pulling it from 'bpimagelist' not as useful?

-- 
Darren Dunham                                           ddunham AT taos DOT com
Senior Technical Consultant         TAOS            http://www.taos.com/
Got some Dr Pepper?                           San Francisco, CA bay area
         < This line left intentionally blank to confuse you. >
_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu