[Veritas-bu] Linux Media Server, Adic Library, and Drivers
2006-10-25 13:38:23
Subject: |
[Veritas-bu] Linux Media Server, Adic Library, and Drivers |
From: |
pcd at xinupro.com (Peter DrakeUnderkoffler) |
Date: |
Wed, 25 Oct 2006 13:38:23 -0400 |
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Is the module for the qlogic hba loaded
lsmod | grep ql
If so, then
cat /proc/scsi/qla2xxx/#
where "#" is whatever controller number it was assigned. If there
is no module loaded, then open up another window with a "tail -f
/var/log/messages"
and while watching that, perform a "modprobe -v qla2300", lets see what
comes out of it. If they are seen at this point, make sure you
have the needed entry in /etc/modules.conf and them create a new
boot image.
Thanks
Peter
Peter DrakeUnderkoffler
Xinupro, LLC
617-834-2352
Brooks, Jason wrote:
> /proc/scsi/scsi only sees the local SCSI bus.
>
> We're running RHEL3, kernel 2.4.21-40.EL with Qlogic 2300 driver
> installed.
>
> Zones look right, but not sure why drive isn't seen. The tape drive is
> a straight FC connect - no backplane in the ADIC (Scalar i2K). The
> server is a Dell with a Xeon, NBU 6.0 MP3, Qlogic 23xx.
>
> Jason
>
>
>>-----Original Message-----
>>From: veritas-bu-bounces at mailman.eng.auburn.edu
>>[mailto:veritas-bu-bounces at mailman.eng.auburn.edu] On Behalf
>>Of Peter DrakeUnderkoffler
>>Sent: Wednesday, October 25, 2006 12:39 PM
>>To: Brooks, Jason
>>Cc: veritas-bu at mailman.eng.auburn.edu
>>Subject: Re: [Veritas-bu] Linux Media Server, Adic Library,
>>and Drivers
>>
> what do you see when you...
>
> cat /proc/scsi/scsi
>
> If it isn't there, then your O/S isn't seeing the drives,
> check your zones again. Also, are you using the included
> qlogic driver to the kernel (which distro and kernel are you
> using?) or have you installed the qlogic Linux drivers?
> There shouldn't be a "driver" for the LTO3 drives, it should
> be seen as a SCSI "st" device and the NBU install should set
> up the SG driver correctly.
>
> There are also great docs included with NBU for this.
> I would also help when asking questions to supply all the data needed:
>
> -O/S version and architecture?
> -NBU version and MP level?
> -which qlogic cards?
>
> Thanks
> Peter
>
> Peter DrakeUnderkoffler
> Xinupro, LLC
> 617-834-2352
>
>
>
> Brooks, Jason wrote:
>
>>We're testing a Linux media server now to try and resolve some NDMP
>>issues. I have the Media server set up, talking to my
>
> Master, fiber
>
>>connectivity to a tape drive (properly zoned), but I can't find
>>drivers. I've contacted ADIC support, but they've been no
>
> help. I've
>
>>found IBM drivers (library contains IBM LTO3s), but they don't work
>>for fibre attached, just SCSI. The fibre attached drivers link to
>>Emulex, but we have QLogic cards.
>
>>Now, I'm about at the end of my rope. Any suggestions? Contact
>>Veritas support? My last hope is to wait on my ADIC Sales
>
> Rep's Engineer.
>
>
>>Thanks,
>>Jason
>
>
>
>
> ----------------------------------------------------------------------
>
>>--
>
>>_______________________________________________
>>Veritas-bu maillist - Veritas-bu at mailman.eng.auburn.edu
>>http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
>
_______________________________________________
Veritas-bu maillist - Veritas-bu at mailman.eng.auburn.edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.1 (FreeBSD)
iD8DBQFFP6EPl+lekZRM55oRAgyqAJ9N0wOcbHNxEYCe6+1HyyTru9v8DgCdHfLq
9w5TMQJR0utw77UtOdTecpc=
=qPDp
-----END PGP SIGNATURE-----
|
Previous by Date: |
[Veritas-bu] Linux Media Server, Adic Library, and Drivers, Brooks, Jason |
Next by Date: |
[Veritas-bu] Linux Media Server, Adic Library, and Drivers, Brooks, Jason |
Previous by Thread: |
[Veritas-bu] Linux Media Server, Adic Library, and Drivers, Brooks, Jason |
Next by Thread: |
[Veritas-bu] Linux Media Server, Adic Library, and Drivers, Brooks, Jason |
Indexes: |
[Date]
[Thread]
[Top]
[All Lists] |
|
|