Make sure you did a prepare to restore, and that the boot server (or
helper) is on the same subnet as the client.
If there is more than one Ignite server on the subnet or if you are
using a boot helper to boot from an Ignite server on a different subnet,
specify the Ignite server to boot from by using the following command
(replace x.x.x.x with the IP address of the Ignite server and y.y with
the gateway):
boot lan.x.x.x.x.y.y
_____
From: veritas-bu-bounces at mailman.eng.auburn.edu
[mailto:veritas-bu-bounces at mailman.eng.auburn.edu] On Behalf Of chodhetz
Sent: Monday, October 09, 2006 9:54 AM
To: veritas-bu at mailman.eng.auburn.edu
Subject: [Veritas-bu] BMR HPUX boot client failed
Dear all,
i'm using BMR 6.0 MP3
BMR Main Server and boot server for hpux installed in NetBackup Master
Server
i want to perform bmr restore hpux client, but when i try to boot client
to BMR boot server, show
Booting...
Boot IO Dependent Code (IODC) revision 4
HARD Booted.
ISL Revision A.00.44 Mar 12, 2003
ISL booting hpux (;0)/bmrpap1/INSTALL
Boot
: lan(0/1/2/0;0)/bmrpap1/WINSTALL
lan(0/1/2/0;0)/bmrpap1/WINSTALL: cannot open, or not executable
Exec failed: No such file or directory
anybody can help ??
Best regards,
Chodhetz
_____
<http://answers.yahoo.com.sg>
Real people. Real questions. Real answers. Share what you know
<http://answers.yahoo.com.sg> .
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://mailman.eng.auburn.edu/pipermail/veritas-bu/attachments/20061009/bc4bf323/attachment.html
|