You don't need a DOS driver for the Perc RAID cards.  The disk read and
writes are allowed using interrupts through the Adapter BIOS.

You will need to make sure you have the right DOS network driver.  If it
is the Dual port Intel-Based GigE, then make sure you hae the correct
E1000.DOS driver - the one made for that card.


-----Original Message-----
From: veritas-bu-bounces at mailman.eng.auburn.edu
[mailto:veritas-bu-bounces at mailman.eng.auburn.edu] On Behalf Of Brooks,
Jason
Sent: Tuesday, August 01, 2006 10:10 AM
To: veritas-bu at mailman.eng.auburn.edu
Subject: [Veritas-bu] Dell Perc Drivers for BMR

We're trying, yet again, to test a BMR restore on a Dell server.  In
order to get it to boot, I've been trying to find a DOS driver for a
Dell Perc 3/di RAID controller.  The only ones I've found are either on
a boot disk or Windows only.  Has anyone had success in using BMR with
this, or a similar Perc controller?  Any suggestions?

Thanks,
Jason

------------
Jason Brooks
Computer Systems Engineer
IITS - Longwood University
voice - (434) 395-2916
fax - (434) 395-2035
mailto:<brooksje at longwood.edu> 

_______________________________________________
Veritas-bu maillist  -  Veritas-bu at mailman.eng.auburn.edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu