-mediaid is to specify the tape was used in your backup, not the files were 
backed up.  Take this option out to see if you can find anything.

-----Original Message-----
From: veritas-bu-admin AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-admin AT mailman.eng.auburn DOT edu]On Behalf Of Rongsheng
Fang
Sent: Tuesday, February 15, 2005 12:58 PM
To: veritas-bu AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] File -> image (backupid) conversion?


Hi list,

I have been trying to find out to which image a file was backed using
bpimmedia(1M) command but always get "no entity was found" message. I
tried GUI, the same thing. I am pretty sure the file I specified in the
command was backed up and I can use bplist(1M) to list it. Here is the
command I used to do the conversion:

  # bpimmedia -L \
        -policy Dev_DB \
        -client devdb2 \
        -d 02/06/2005 00:00:00 \
        -e 02/06/2005 11:59:59 \
        -mediaid /u01/ora/INST/indx01.dbf

Did I miss anything in the command? Or are there any other ways to do
this?

Thanks,

Rongsheng
_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu