You can use bpend_notify found in the "goodies" directory.

Just move this to Netbackup/bin, make it executable and add your
specifics.

#
# This script:
#       receives 5 parameters: CLIENTNAME POLICYNAME SCHEDNAME SCHEDTYPE
STATUS
#       must be executable by the root user
#       should exit with 0 upon successful completion

The last item received is the STATUS.  Just make sure that bpend_notify
exits successfully (exit 0) otherwise, you'll have problems.

David A. Chapa | ADIC | 720.272.8452 cell | http://www.adic.com 
Sr. Technical Advisor 




-----Original Message-----
From: veritas-bu-admin AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-admin AT mailman.eng.auburn DOT edu] On Behalf Of
anouar.elmourabit AT edb DOT com
Sent: Thursday, October 07, 2004 6:09 AM
To: veritas-bu AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] Batch job on NetBackup 3.4.1

Hi!

I need to run a batch job after a specific NetBackup job has finished.
I want to extract the job status (0/1) and use this info to perform a
delete job if the status is 0.
I know BackupExec has the possibility to run batch jobs before and
after, but can't find the same functionality in NetBackup..

Thanks in advance!

Regards,
Anouar El Mourabit

_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu