All,

I'm having a problem configuring a DLT drive.
I want to add it as an standalone drive.

It's a DLT7000.

Every time I add it, it's shown as AVR

                                  DRIVE STATUS

Drv Type   Control  User      Label  RVSN    EVSN    Ready   Wr.Enbl.  ReqId
  0 4mm      OPR               Yes   WED-B            Yes     Yes       -
  1 dlt      AVR                -                     No       -        -

Any ideas ?
I know there are options to configure the drive (DLT, DLT2 and DLT3).
I have tried all of them, however, is there any special I should use ?

Thanks a lot !

Carlos