On Mon, Jul 23, 2001 at 09:04:49AM -0400, Rohloff, Brent CSC wrote:
Brent,
We had similar problem.
I turned out L700 had a bad SCSI cable, it was a factory defect.
All tape drives including robotic device showed
similar problems. Since the cable was replaced we never had problems
again.
Thanks,
Andrew
> DLT drives are getting tapes stuck in them ?
>
> I've got a StorageTek L700 with four DLT drives,
> DataCenter 3.4, Solaris 2.6
>
> Over the past 6 months, occasionally a drive would get a tape hung in it.
> The StorageTek Tech said it looked like the eject lever broke and replaced
> two of the drives.
>
> I had three of the four drives get hung up this weekend, including one of
> the replaced drives.
> The fourth drive worked until this morning, when it went to change tapes, it
> got stuck too.
>
> Now all four drives are hung up and the StorageTek guy is on the way.
>
> Has anyone seen this ?
> Could it be the robot is breaking the eject levers on the drives ?
>
> I tried upping the drives from NetBackup,
> tried ejecting the tape from the L700 front panel,
> tried opening the L700 and pushing the button and lever on one of the
> drives.
> No luck,
>
> Thanks in Advance,
> Brent
>
> Brent Rohloff
> UNIX Admin
> CSC at Sikorsky Aircraft
> brohloff.csc AT sikorsky DOT com
> _______________________________________________
> Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
> http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
--
----
Andrew Shinkarev
Network Systems Specialist
Abbott Laboratories
(847) 9387559
shinkara AT pprd.abbott DOT com
|