Hello everybody !

I'm now getting crazy with this NDMP ....

I configured our NetApp Filer with 2 DLT7000 out of the STK 9740 Library. In the
Device Manager the drives are available via /ndmp/... and UP. Fine ...
I want my Solaris Box to control the STK and the other 6 drives, so I left the 
robotic control, where it was ...
This is what tpconfig shows now:

  0   QUANTUMDLT70000        /dev/rmt/0cbn            dlt      No        UP
        ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=0
  1   QUANTUMDLT70001        /dev/rmt/1cbn            dlt      No        UP
        ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=1
  2   QUANTUMDLT70002        /dev/rmt/2cbn            dlt      No        UP
        ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=2
  3   QUANTUMDLT70003        /dev/rmt/3cbn            dlt      No        UP
        ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=3
  4   QUANTUMDLT70004        /dev/rmt/4cbn            dlt      No        UP
        ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=4
  5   QUANTUMDLT70005        /dev/rmt/5cbn            dlt      No        UP
        ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=5
  6   DAB-FS30_STK9740_Drive /ndmp/nrst0a             dlt      No        UP
        ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=6
  7   DAB-FS30_STK9740_Drive /ndmp/nrst1a             dlt      No        UP
        ACS(0) Definition       ACS=0, LSM=0, PANEL=1, DRIVE=7

The set_ndmp_attr -verify are running as well ...

Now I set up a NDMP Class with a NDMP Client, start a manual backup and 
Netbackup queues
the job and ends up with code 213 - no storage units available for use ...

Where did I misconfigure this device configuration ?!?

Regards

Axel Kunze