After you update the st.conf, you will most likely need to use the admin
tool for your SAN to designate the world wide definition of the devices.  At
least this is what I had to do on our environment.

Dan Sixbury


-----Original Message-----
From: Matthew Tole [mailto:matt_tole AT yahoo DOT com]
Sent: Thursday, March 01, 2001 1:12 PM
To: veritas-bu AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] sgscan oddity


I am having a problem getting solaris is assign a
device file for a tape drive on a fabric SAN. When I
do an sgscan I get:

/dev/sg/c0t6l0: Disk (/dev/rdsk/c0t0d0): "SEAGATE
ST336704LSUN36G"
/dev/sg/c2t0l0: Changer "STK   L180"
/dev/sg/c4t2l0: Tape (???): "STK   9840"
/dev/sg/c5t0l0: Tape (/dev/rmt/0): "STK   9840"

I have checked the st.conf to make sure that there are
enough lun assignments but short of that I am stuck.
Any ideas.

MT


=====
Matthew Tole
Systems Engineer
PWI Technologies
W(425)576-2153 CLR(425)445-6361

__________________________________________________
Do You Yahoo!?
Get email at your own domain with Yahoo! Mail. 
http://personal.mail.yahoo.com/
_______________________________________________
Veritas-bu maillist  -  Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu