[Veritas-bu] Restore From NDMP Backup
2001-02-21 16:56:37
With my introduction to NDMP I must say I'm sure getting my moneys worth from
this list now.
Still another NDMP question.
How the heck do you do a restore? I've used the procedures in the NDMP book and
made sure the Server tab points to the NBU Master and the other two tabs point
to the NDMP host server. When I submit the restore everything looks OK at the
start but we end up getting a ERROR 5 (the logs show a STATUS 227) and the docs
are a little loose in their explanation on what could be going wrong. There's
also something about an INTERNAL ERROR. The restore is from a snapshot.0 file
that was backed up a couple of days ago. I've tried restoring to the original
location, restoring to an alternate location ... etc; and nothing seems to
work. Does anyone have a good piece of doc that describes the restore process
for data to a NetApp? I think the problem lies in the fact that I'm trying to
restore back to the snapshot.0 file. I'm beginning to understand the e-mails
from a few weeks ago titled "Why I Hate NDMP". This whole process (set-up,
backup, restore) is certainly not intuitive by any stretch of the imagination.
Any info would be greatly appreciated.
Regards,
Dennis Dwyer
Tampa Electric Company
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
- [Veritas-bu] Restore From NDMP Backup,
Dennis Dwyer dfdwyer <=
|
|
|