In regard to: [Networker] Linux RHEL 6.4 client issue, Matthew Powell said...:

Anyone have a Linux RHEL 6.4 client that could push a save to the server
which is Networker version 8.0 on Solaris 10 but the backup server not
be able to get to the client from a save job. Get RPC error, program not
registered. Firewall is off and still no luck. Any suggestions would be
most appreciated. Thanks and have a great day.

Joe already mentioned that selinux should be disabled on the RHEL client,
or the RHEL client admin needs to make the (unsupported) changes to
the selinux attributes on the client to get it to play nicely.  Those
have been posted to this mailing list in the past.

Also, if the RHEL 6.x client was done as a minimal install, it probably
doesn't have rpcbind installed.  nsrexecd has some built-in
portmapper/rpcbind capability, but I've always found that it works
better if portmapper or rpcbind is running on the clients.  Have the
client admin check that rpcbind is installed, enabled for auto-start,
and running, and then have him or her restart nsrexecd.

You may also want to run

        rpcinfo -p the-client-name

from your NetWorker server, to see if it can see nsrexec or program #
390113.

Tim
--
Tim Mooney                                             Tim.Mooney AT ndsu DOT 
edu
Enterprise Computing & Infrastructure                  701-231-1076 (Voice)
Room 242-J6, IACC Building                             701-231-8541 (Fax)
North Dakota State University, Fargo, ND 58105-5164